1.  The installation of the server. 7 to 50 liters server can choose wall-mounted or vertical installation, according to the customer on the spot standard clear installation method. If it is wall-mounted, it is the same as the outdoor air conditioner, hanging on the wall, the installation method and the outdoor air conditioner installation method is the same, first the three-legged support frame fixed immobile in the wall, and then the dispersion oxygen machine fixed immobile in the three-legged support frame on the side. If you choose vertical installation, the rules, the bottom of the machine and equipment and the road to maintain a distance of Z less than 15 cm, (to avoid the extremes of heavy rainfall temperatures, road storage water invasion into the machine and equipment). There should be no obstruction within 20 cm of the air inlet of the machine and equipment to prevent all normal air supply to the machine and equipment from being jeopardized. The machine and equipment should be placed at a level, the up and down skewed perspective of not more than 20 degrees.
2. GBS terminal installation, GBS terminal package inside a hard paper strip, the paper strip on the upper side of two holes, the paper strip level placed on the wall, the height and width ratio of 1.8 meters to two meters above and below the ground. Mark the area of the two holes on the top of the paper strip with a signature pen. Use 6 mm twist drill to open holes in the two areas marked, the depth of about 5CM up and down. Install the plastic pescado sleeve in the well-made hole. Then screw the dowel into the plastic surge sleeve. Note that it is not necessary to screw in all, pre-bury 0.4CM, and then hang the terminal immediately on the two dowels on the side. Terminal vents do not need to have objects within 30 cm. To prevent endangering the actual effect of terminal diffusion oxygen.

Dispersion oxygen generator and GBS terminal each take power independently, if the host power line is not enough, you can use the power plug in the auxiliary material to increase to the room to take power. The terminal takes the same power as the server. After the diffusion oxygen generator and the terminal are powered separately, the server and the terminal are connected with oxygen tubing. Add the two-core signal line built into the server with the core signal line in the auxiliary material, and then connect the two ends of the 2-core signal line to the wiring port number on the right side of the GBS terminal each. (2 core signal line connection can not be divided into positive and negative). It is proposed that the oxygen tube and signal line outside the modified waterproof sleeve. Waterproof sleeve for the diameter of 25mm or 30mm general PP waterproof sleeve or wire channel. Wiring as far as possible to ensure horizontal flat. Ensure beautiful and generous.